YOUR GENESIS Stabilizers
Carbon will dissipate vibration much better than hydraulics, mercury
Each carbon rod is fitted with an aluminium insert cap. The carbon
rods function individually, much the way a tuning fork performs. This
configuration greatly dampens shock and vibration.
The sliders are aluminum with 1/2" stainless
steel weight, and allow the stabilizer to be fine tuned by moving the
slider forward or backward.
If the group is vertical, the slider must be moved back. If the group
is horizontal, then the slider must be moved forward. Moving the slider
in small increments will allow the group to become larger or smaller
as it is repositioned.
There are rubber pads underneath the set screws on all of the sliders.
Care must be exercised when tightening the set screws as carbon can
be crushed by over tightening.
Periodically check the set screws in the sliders, especially the Delrin
sliders. Heavy vibrations can sometimes cause them to loosen.
Your stabilizer will give years of service if care and maintainance
>Back to top of page